Shopping Cart
4 Channel 4x5A DMX512 & RDM Decoder - D4-L
- Comply with DMX512 standard protocol
- Easy to set DMX start address using buttons and Digital Numeric Display
- RDM function
- 1/2/4 DMX Channel output selectable
- Standalone RGB RGBW and 4 channel dimmer mode for controlling the system by buttons instead of DMX
- PWM selectable 250/500/1000/2000/4000/8000/16000Hz - Please note, above 2000Hz the total power will be less than the nominal power.
- 16bit (65536 levels) /8bit (256 levels) grey level selectable
- Logarithmic and linear dimming curve selectable.
SYSTEM PARAMETER SETTINGS
- Long press M and ◀ key in the same time for 2s, prepare for setup system parameter: decode mode, grey level, output PWM frequence, output brightness curve, default output level, automatic blank screen. short press M key to switch six item.
- Decode mode: short press ◀ or ▶ key to switch 1/2/4 channel decode mode(”d-1“,”d-2“ or ”d-4“). When set as 1 channel decode, the decoder occupy only 1 DMX address, and four channel output the same brightness of this DMX address.
- Grey level: short press ◀ or ▶ key to switch 8bit(”b08“) or 16 bit(”b16“). choose 16 bit if the DMX master support 16 bit.
- Output PWM frequency: short press ◀ or ▶ key to switch 250Hz(”F02“), 500Hz(”F05“), 1000Hz(”F10“), 2000Hz(”F20”), 4000Hz(”F40”), 8000Hz(”F80”) or 16000Hz(”F16”). Higher PWM frequency, will cause lower output current, higher power noise, but more suitable for camera(No ickers for video).
- Output brightness curve: short press ◀ or ▶ key to switch linear curve(”C-L“) or logarithmic curve(”C-E“).
- Default output level: press ◀ or ▶ key to change default 0-100% level (”d00“ to ”dFF“ ) when no DMX input signal.
- Automatic blank screen: short press ◀ or ▶ key to switch enable (”bon“) or disable(”boF“) automatic blank screen.
- Long press M key for 2s or timeout 10s, quit system parameter setting.
DMX mode
- Short press M key, when display 001~512, enter DMX mode.
- Press ◀ or ▶ key to change DMX decode start address(001~512), long press for fast adjustment.
- If there is a DMX signal input, will enter DMX mode automatically.
- DMX Dimming: Each D4-L DMX decoder occupy 4 DMX address when connecting the DMX console. For example, the defaulted start address is 1, their corresponding relationship in the form: see in the manual.
For standalone dimmer mode, factory reset, RGB animation, problem solving see the manual.
